You are reading a single comment by @Howard and its replies.
Click here to read the full conversation.
-
Think this is a bit of a mess because it looks like the waste pipe was too high - or bath too low, necessitating that curious looking bit of pipe and the slightly shonky angles.
I would try to take it off and clean it all up and attempt a better seal as best I could but be warned it might be glued in somewhere so getting it off might not be straightforward.
Howard
Ramsaye
Just had water dripping through the hall ceiling, it was while the bath was draining so I took off the panel and saw this. It tightened a fraction by hand so i reckon I’m onto the cause here, plus the floor underneath was sodden.
Is the longer fix just a case of removing, cleaning, adding some ptfe tape or should I be replacing the white bits?