You are reading a single comment by @hp93 and its replies.
Click here to read the full conversation.
-
With no knowledge of motorcycle brakes, I’d say no, if the brake works, it works. No need to bleed anything. Just looks like you need to rewire or replace that connection
-
unscrew
If it's a regular banjo bolt pressure switch like this then the act of unscrewing will mean you'll have to rebleed the system. Did mine recently in about 30mins so too bad, just take your time. Although granted if your MOT isn't for a while then not mega urgent.
PhilDAS
jambon
pdlouche
@hp93
So, earlier than I was hoping, but need a little advise on maintenance!
I’m hoping this is as small a job as I think it is. I’ve noticed the rear brake is not actuating the light (but front brake is)
I’ve isolated the issue (worn cable) and found a replacement.
Now all I need to know is, will I need to bleed the brake (I hope not), or is it just unscrew and screw back in?
I can get some better photos without that plate on tomorrow.
2 Attachments