You are reading a single comment by @jontea and its replies. Click here to read the full conversation.
  • getting the pressure equal on both sides

    I found this to be easier on cantis than Paul tbh. The only issue sometimes is rounding off those tiny allen bolts sometimes.

    They are great brakes though.

  • Due to being centre pulls and the fork mounting plate, if one bits off, then it's a whole restart from scratch, as any tiny adjustment just makes matters worse.
    They'll be a lot easier to set up once direct mounted, if the recessed bolt mounting plate is slightly out then everything is miles out, but once square they were ok.
    Agreed, although I only tested it around the block (yes, it's weekend, therefore it's pissing down in Cheshire), it feels better than a normal caliper.

About

Avatar for jontea @jontea started