You are reading a single comment by @umop3pisdn and its replies.
Click here to read the full conversation.
-
10mm will be way too big, I think even 5mm would be big for a knife handle. Especially if one of the groomsmen has a particularly long name.
-
Yeah they look good, might go for smaller letters but I see they've got some and as you suggest I was anticipating needa piece of steel plate to put into the middle of the handle while stamping...
I was mostly concerned about needing a special stamp for brass but I'm sure hardened steel will be fine?
Might buy an extra knife for myself to practice on before I do the other ones...
chiroshi
Nahguavkire
@umop3pisdn
Something like this ?
Might have to have something to fill the void in the handle.