Any question answered...

You are reading a single comment by @CYOA and its replies. Click here to read the full conversation.

•

gbj_tester in reply to @CYOA

some very precisely threaded holes

How many? How precisely?

•

CYOA in reply to @gbj_tester

Yes.

Don't have a design in mind yet but top of head - 20 x 3/8-16 thread and 10 x 1/4 20

Precisely enough that if I screw a spigot in it stays in firmly / doesn't damage the spigot or the plate?

I've seen this which is similar but not the right size and doesn't need the thread in the side profile at the end - 3D printed, too, so I have doubts about longevity. https://www.lsdigi.com/products/3-8-16-accessory-cheeseplate

•

gbj_tester in reply to @CYOA

I'd probably go to a fabricator rather than a machinist, mostly because you're more likely to get powder coat as part of the service and they can easily meet the accuracy required.

About

Avatar for CYOA @CYOA started