You are reading a single comment by @gbj_tester and its replies.
Click here to read the full conversation.
-
You can pass an extension through the centre to tighten left-hand threaded cups with a clockwise motion. For pedals, it depends what tool interface you have - 8mm hex socket in the back and 15mm flats on the front means you just need a crow's foot to do the one which is right-hand threaded. If you only have flats, the crow's foot needs to be long enough for an extension to pass the crank from the back. If you only have hex sockets, then you actually need a torque wrench which works both ways 🙂🙃
gbj_tester-
There are a number of #lifehacks, including reversible ‘crow’s foot’-type BB adapters like the one below, but I’d rather just get a tool that can swing both ways.
ectoplasmosis
Does the 20-100Nm version measure torque in both directions, clockwise and anti-clockwise?
Looking for something that can do BB and pedals.