You are reading a single comment by @absurdbird and its replies.
Click here to read the full conversation.
-
I guess it makes sense to cut the panel over the horizontal stud and just notch that
Yeah exactly (horizontals between studs are called noggin(g)s - also between joists)
Or you could cut along midpoint of the noggin and neighbouring stud to give something to attach your patch to, then you can drill down, this has the disadvantage that you’re working blind below the noggin.
Don’t forget to put electrical tape over the ends of the pipes to prevent Victorian detritus in yer plumbing.
absurdbird
Thanks, that makes sense and thankfully I have all three of those options available!
I guess it makes sense to cut the panel over the horizontal stud and just notch that, rather than cutting a larger hole above/below to get a drill in for the stud. Should mean a much smaller hole if things go to plan...