You are reading a single comment by @Dammit and its replies.
Click here to read the full conversation.
-
If the bent cam arm is also a problem could it be straightened?
Not by what I've tried so far. I may have to step up the amount of force, and possibly introduce some heat.
However, I may not need too as the dimensions of this are very close (only the prong is too long, but I could cut that down).
Dammit-
👍
As long as the depth of the body isn’t too long (so the seal connects before your threads bottom out) and the threads and the splines work, the other bits (length and diameter of the ‘leg’) should be fixable. -
However, I may not need too as the dimensions of this are very close (only the prong is too long, but I could cut that down).
And four quid is usefully cheaper than Lunns ...
absurdbird
jsabine
Is the problem that it doesn’t seal or also that it isn’t working as a diverter?
If it’s just leaking you can maybe fix with some good pipe sealant and PTFE and a new rubber seal.
If the bent cam arm is also a problem could it be straightened?