You are reading a single comment by @konastab01 and its replies.
Click here to read the full conversation.
konastab01
-
...
-
Total stab in the dark, assuming its approx 8cm to 10cm long?
An hour to measure and model £25, 0.25 hour to slice and setup printer, prob 2 to 3 hours to print depending on density. So for an amateur you'd be paying £30-40 for the 1st one.
Then around £1 per part after that -
It looks like it might be thin walled from the left hand corners, not an ideal part for 3D printing if strength is important. If it’s just a cover or similar non load bearing part then would probably be fine. More pics would be helpful, ideally with a scale..
pdlouche
BrickMan
99wombats
Post a pic of what it is. ABS for printers is mad cheap now, £15-30 a kg, its the time thats the cost, material and actual printer time is very low cost these days.