You are reading a single comment by @Thrasher and its replies.
Click here to read the full conversation.
-
from 5.25 - https://www.youtube.com/watch?v=dvc2WdvIgVk&t=7s
Thrasher-
appreciate the general idea.
what's the name of a 2 to 1 connector for this?
I aim to have 2 pairs of cables coming out from the hub that can then split for the sinewave and the supernova light.
Is there something I can buy at least for the end towards the hub that can solve this? like a two head cable from the dynamo hub connector on where each head has inside the two cable...dont' know if I can explain this any better :P my apologies..
Albb
Hi,
in search of good advice.
I have run before my supernova in the front wired with the e3 tail light.
However, I would like to install a sinewave (or very similar inverter) to keep my stuff powered.
What should be the best way to wire / cable them?
Should I run the sinewave cables directly into the hub + running the supernova front cables too into the hub or should I add a splitter somewhere and what type?
I have a rodeo dynamo fork therefore I would like to do a neat job trying to disguise the cables as much as I can.
forget to say that the new hub will be a SON.
Ty in advance