-
Thanks for the tips. I had seen that California Patch method before (just wasn't aware of the name). I want to try it for some of the smaller patches (door handles and no door stop etc).
The battens are pretty close to the edge (probably about an inch) and the right side is over the edge of a stud, but if I notice movement, i can easily redo. This is in the "utility room" which is basically just a small hallway before the kitchen and we're nowhere near ready to decorate, so happy to be experimenting.
Actually, thinking about it, it is just the right height and location for someone to have backed their arse into the wall getting something out of the washing machine. Although, it's not a narrow space so they were either pissed and fell, or particularly stubborn duvet came loose as they were wrestling it out of the Beko.
You are reading a single comment by @stevo_com and its replies.
Click here to read the full conversation.
stevo_com
absurdbird
I usually support the plasterboard
around all the edges with some ply or something to stop movement - which can end up cracking.
Also any movement in the board can allow a ridge to form when you’re skimming.
Edit; Is the left side cut back to the next stud? In which case after some glass tape and screws both sides of the vertical joins -you’re good to go.
The original hole was at the large end of what is suitable for a California Patch which is a quick and cool way of patching holes in PB.
You square up your hole, cut your patch about 100-150 mm bigger, score the back to the size of the opening then snap and peel off the excess pieces. This leaves you with a patch with an overlapping front face of paper which you then just stick in place with plaster and skim over.
It’s kind of hard to explain.
https://youtu.be/17awCvAA7Q0
I was shown how to make them by a hippie plasterer in California- 😎