You are reading a single comment by @moog and its replies. Click here to read the full conversation.
  • This is very helpful. What foot are you using? I think I've finally found a position that works okay with my machine, but the 1" tape (definitely the correct width for the attachment) just always wants to slip down/around, usually so there's more underneath than on top.

  • It's been a while since I used it but I think it was just the standard foot with the needle position offset to get closer to the binding edge. I just had a look at the last binding I did and the top/bottom balance is pretty equal, getting the binding really tight to the fabric edge was more of an issue for me.

    If I get time at the weekend I'll set it up and can take a few photos.

About

Avatar for moog @moog started