Alright, thanks! This helps a lot. From what I have seen I think the frame is integrated then. So that means I only have to figure out the angles, right? Is there any clever way to do this?
Googling is your best bet. There might be a spec sheet somewhere that tell you what headset it has/needs.
Perhaps someone else knows an at home way of accurately measuring mating surface contact angles?
The angles will probably be written on the side of the existing bearings.
Alright, thanks! Learned a bit more, so all that's left then is more intensive googling and/or contacting Olympia. Cheers.
@Eseman started
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Alright, thanks! This helps a lot. From what I have seen I think the frame is integrated then. So that means I only have to figure out the angles, right? Is there any clever way to do this?