You are reading a single comment by @Acliff and its replies.
Click here to read the full conversation.
-
But would. Grinder give a consistent edge on 5 separate aluminium pieces?
Attached pic of profile.
1 Attachment
-
Acliff
-
You can always clean up the cut edge with a file after. Not sure I would trust a jigsaw on that.
-
Flip it over and go through the back - the grinder basically wants to cut straight lines.
If you have access to a mitre saw, a multi blade would do that nicely.
-
You could build a chop saw jig for the grinder. Or just use an old blade on a chop saw / circular saw,
-
made me think of this
Sharkstar
Dramatic_Hammer
NotThamesWater
plantasia
I would use a grinder for that personally.