Home DIY

You are reading a single comment by @Sharkstar and its replies. Click here to read the full conversation.

•

NotThamesWater
Finally finished gluing!

Next up, after drying overnight
- drill the cutouts
- rough trim the edges
- plane the top
- flush trim and rout the edges
- sanding
- varnishing
I may put a brace across the bottom too, to give a little extra stability for when my desk is at full height.

•

Sharkstar in reply to @NotThamesWater

I always find you get little holes in ply edges. Are you planning to spot fill before sanding?

•

NotThamesWater in reply to @Sharkstar

I've done a lot of filling already, using various thickness (down to well below<1mm) strips of ply that i ripped.

Once I've planed it, I'll be filling with glue & sawdust.

About

Avatar for Sharkstar @Sharkstar started