You are reading a single comment by @grams and its replies.
Click here to read the full conversation.
-
You only need to get the plugs through the holes.
Use extra long cables and route them all out the top of the seat tube, plug them in, then drop the junction B down.
grams-
Down where? It's not fitting through either of those holes.
Edit - down the top of the seat tube. Sorry, I'm a bit slow today.
-
I thought about that, but it's a lot of extra wires to fit in. My Strael has an extra long wire to the battery and it's a bit of a fiddle to get the seat post back in. The bottle mounts block the tube on the inside, I doubt that a junction B would fit past them.
-
This is my plan what I hope to do and then the junction box will probably end up sitting above where the top bottle boss enters the frame. Thanks for the answer on the SD300 cables!
Brommers
cjr
SoYaap
I knew there were headset options out there but it all looked a bit complex. Either way, a guy was selling the same frame on ebay and kindly sent me a pic of the Bottom Bracket shell. Doesn't look like I could fit a Junction-B inside either the down tube or seat tube so unless there is a magic way to enlarge the holes, I'll probably not bother.