You are reading a single comment by @Skülly and its replies.
Click here to read the full conversation.
-
A few options:
1) The housing guides but instead of a zip tie use some clear fishing line wrapped a few times around cable tight and then a drop of clear superglue to hold it together.
2) The ART 151 should be small enough ID to give friction for the 3mm SON cable to allow some tension. If not a wee bit of head shring over the section passing through them could work.
motoko
@Skülly
All interesting thoughts. I want to avoid using any cableties, I hate them. Also the closed rings aren't my bag since I'd like to be able to add a little tension to the cable, then secure. I think tiny threaded bosses (or simply a nut brazed on) with either a washer (and loop the cable around once before tightening) or some very small PClips off the side of the boss is my favourite solution. That will keep the cable very close to the tube, if the Pclip is mounted flat side up, so the cable is alongside the boss against the tube.