PhilDAS never content with the bikes I already own

You are reading a single comment by @PhilDAS and its replies. Click here to read the full conversation.

•

deleted

I don’t know how you drill holes, but in my experience drilling 2 2mm holes is at least 500 times faster than dicking around with resin and carbon matting. Would also be a lot easier to make sure it’s at the correct height.

•

PhilDAS in reply to @deleted

No that's true. I have a bench drill and a pack of new bits. It's not the speed of drilling, just that I'd rather add strength than take some away or introduce points of failure underneath my precious bottom.

•

hp93 in reply to @PhilDAS

my precious bottom.

It’s not that precious.

Is adding stops for the post to stop it slipping into the frame not just creating a new stress point at the frame/stop section?

Surely someone on here can 3D print an ISP topper for it! Then you just glue the post in place and not have to worry about it.

About

Avatar for PhilDAS @PhilDAS started