You are reading a single comment by @Polygon and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Polygon
Airhead
My favourite for spindles etc are the soft pads in a fairly aggressive grit. Maybe the scraper set I linked a few pages ago might help too. There's no getting around it being a slow job though.
The ir stripping relies on the ir heating the wood under the paint so there's a good chance it would lift an oil based varnish, not so sure about water based. I don't think it would lift the stain but once the varnish is gone the stain should be easier to remove.
My next DIY project is to clean up a piece of oak that's worn and stained inside the patio doors where it gets stepped on during the winter. I will try ir on it just to see what happens.