You are reading a single comment by @Bobbo and its replies. Click here to read the full conversation.
  • Yeah you're right, I hadn't considered that benefit. In that scenario I normally put a piece of scrap butted against the side end of the cut to prevent the chip out. Stops that dust ejection as the blade exits the piece too.

    Out of interest what blade/saw are you using?

  • I use a Bosch saw and usually a 40t Freud blade, I find Freud blades to be excellent and they are my go to for all of my tools. However they don't make a blade with a higher tooth count for a 165mm saw so normally go for one of the 52t Axminster ones.

About

Avatar for Bobbo @Bobbo started