You are reading a single comment by @dbr and its replies. Click here to read the full conversation.
  • OK, this isn't a money making tool. I just want to not feel frustrated with the result at the cost of 200£

  • The blade change on the Mafell is lovely, but you won’t miss it if you don’t have it😉

    Seriously though, I rarely change from a 48t Freud blade. If you’re cutting panel products neither will you. Only time I swap if I’m ripping solid timber (like a glued up table top) or cross cutting ply or timber at an angle, then it’s a low tooth count blade.

    Get the Bosch and spend the extra on tracks. I have a 1600mm and a 2700mm made from two sections - works for all my needs in the workshop and on site. They’re Bosch rails (but I have a Mafell) same rails, different logos. All made my Mafell. The joining system means the long one in two sections is never not straight.

About

Avatar for dbr @dbr started