-
The bits with this driver are a larger diameter, so my usual bits wouldn't fit as they're loose in the driver. Matt mentioned this would be the case when I collected it.
The reviews online, and that video, show the tool works fine. I'm certain it is my incompetentce that is the limiting factor.
I only needed to remove appx 80 shelf screws and i've not managed to shift 45 of them, for the time I've spent around this today I'm at over 15 mins per screw.
Epic fail thread >>>>>>>>>>>
rhb-
Ah, is it a hammer strike one? They’re good for machine screws etc that need “cracked” but less good for tight wood screws. If someone can lend you an 18v cordless impact driver, it’ll make a world of difference. I’d offer to help, but I’m a little far north unfortunately.
Failing that, dig out around the end of the screw, and use the jaws of the Chuck to remove the screw.
-
Can’t remember where you are but you are welcome to borrow my driver from Deptford way
-
remove appx 80 shelf screws
And I thought 606 needed a lot of screws...
Nef
Sharkstar
Howard
Don’t use the black screwdriver “impact” bits, they’re always shite.
Use normal gold/grey wera and accept that they’ll explode every now and then. The black impact bits don’t seem to grip the heads very well IME.