You are reading a single comment by @M_V and its replies.
Click here to read the full conversation.
-
They use a plain threaded axle with no shoulders for the bearing to sit on. This means axial loads are not so well supported and it also allows the bearings to be over preloaded on setup. The come nuts sleeve inside the bearing (so the bearing has a flat surface to sit on rather than thread) meaning the bearings are smaller than could otherwise be used.
M_V-
ok you're telling me something i don't quite know... it sounds to me like miche uses the same design as old vintage hubs (which is the only thing i know) BUT with sealed bearings... am i right? WHILE other hubs use another design i'm not aware of
what about novatecs?@Skülly
we are talking ambrosio zenith right? ok notedalso thank you everybody for the infos!
shaani
miche flawed? in what way? care to explain?