You are reading a single comment by @fizzy.bleach and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
fizzy.bleach
Probably. I doubt that the parts will be ground - turned from bar stock with flats milled on the sides, maybe? The surface finish requirement is probably to make sure they get hand sanded after machining so they look nice.
I reckon +/- 0.05” (0.13mm) on the length is probably about right for parting off on a manual lathe with no second-op machining.