Electronic & Hydraulic Shifting (Di2, Ui2, customisations)

You are reading a single comment by @grams and its replies. Click here to read the full conversation.

•

hippy in reply to @atz

I'm not sure if it 'zeros' the microadjust when you plug in a new mech. I assumed the Junc A just keeps whatever was set but I've never tested this.

•

grams in reply to @hippy

The adjustment values are stored in the battery because of course they are.

IIRC it does keep the same values when you change mechs.

If the B screw is too far out shifting on the smaller cogs suffers.

•

atz in reply to @grams

Is there any way to reset the microadjust in the etube app or is it just a case of maxing it out one way then backing it the other way 16 clicks?

About

Avatar for grams @grams started