You are reading a single comment by @chrisbmx116 and its replies. Click here to read the full conversation.
  • May have changed, but when I wanted to do this Tado didn't support electric underfloor.

    They do, however, have a connection for a hot water relay, immersion heater I guess. It's got a relatively low amp rating but if your heating mat is less than the rating it'll be fine. I have a flex going from the control thing to a spur outside the bathroom, that goes to thermostat on the bathroom wall, then down to heating mat. You need a thermostat in the loop so it doesn't just melt after being permanently on.

    Well into telling google to turn the bathroom floor on in prep for a shower when I come back from a cold ride.

  • Just did some reading, Tado doesn't support over 3w leecy floors, which is 3 sqm and above. My bathroom is 3.2 of floor so may just be doable.

    Your set up sounds over may head though!

About

Avatar for chrisbmx116 @chrisbmx116 started