You are reading a single comment by @Mr_Sworld and its replies.
Click here to read the full conversation.
-
I'd be wary about drilling through the back or sides, too easy to hit a refrigerant pipe. I just slightly enlarged the drain hole, cut the plug off the heater to pass the cable through and rewired. The Inkbird thermometer probe when straight through.
I left my fridge stat in place, just turned it to max. But I want to be able to sell the fridge again if needs be so didn't want to do anything drastic.
Mr_Sworld
Did consider it yeah, or just drill a hole through to the compressor cavity, not sure if that's an incredibly bad idea though I haven't had a proper look yet. Either that or feed it in where I'm taking the existing thermostat out.