You are reading a single comment by @Brun and its replies.
Click here to read the full conversation.
-
Yes. I am an idiot and managed to do it without breaking anything. If you are lucky there will be shutoff valves at the end of the tap tails. I had to slightly enlarge the hole in the worktop but as it was wood that was no issue with sandpaper.
-
If you turn your mains stop cock off for the cold it’ll kill the hot too, so don’t worry about that
NickCJ
konastab01
@Brun
On the subject of taps. Replacing a kitchen mixer tap should be a DIY job, right? I can see where to isolate the cold water supply, haven't checked into the hot yet but it's direct from a combi boiler.
Are fittings standard - presumably just the size of the single hole? Current one is Ikea, courtesy of previous owners.