You are reading a single comment by @e54 and its replies. Click here to read the full conversation.
  • Spacers on both sides are identical and the wheel is centered

    If it's centred between the dropouts, it might not be centred between the brake posts. The position tolerance when they were welded on probably wasn't super tight, and it doesn't take much to throw the angle off to a noticeable extent.

  • Many thanks, very helpful as always

    Does that mean i can still run this frameset (fork) with mini-vs only or is that too way off so that I should switch to cantis instead?

    (Option 1 preferred ^_^)

  • i can still run this frameset (fork) with mini-vs

    Yes, it's fine. Mini-Vs are designed to accommodate axial runout in the rim (which as far as the brake is concerned is what asymmetric stud locaction is) without its feeding back into the cable. That's just one of the many advantages over cantilevers.

About

Avatar for e54 @e54 started