You are reading a single comment by @mi7rennie and its replies. Click here to read the full conversation.
  • Still looking for way to fit a dyno light to my dads suspension fork crown.

    Thinking about a very long cap screw to tension the headset, then screw a tapered bung into the bottom of the steerer with some sort of mounting feature on it.

    Or maybe a steel p clip with rubber around the forks lower leg.

    Not sure how we manage the cable over the suspension travel either.

    All ideas welcome.

  • I just left some cable slack no issue with it. And I mount the light on the bars.

  • Can't you just put a star nut in the bottom of the steerer?
    Because good luck finding that long screw.
    Or as Skinny says, handlebar mount.

  • Depending on the fork, what about a hole through the cross brace??

  • Not sure how we manage the cable over the suspension travel either.

    If you don’t figure out a way to avoid travelling across the suspension, you could perhaps try making the cable section there into a curly phone-style cable. Very easy to do, looks awesome and neat, I use this to traverse between fork crown and frame for rear light cabling. Can show you pics of my setups later. Basically you wind the cable tightly like a spring around a screwdriver stem, and gently heat the wire.

About

Avatar for mi7rennie @mi7rennie started