Marin Team Titanium, Stumpjumper Comp: obsolete 90’s toss and a Stayer

You are reading a single comment by @ectoplasmosis and its replies. Click here to read the full conversation.

•

Multi_Grooves in reply to @ectoplasmosis

I had the disc tab done by Patrick at Limit Fabrications.

Fantastic service and result, couldn't be happier. Patrick made custom tabs to fit the caliper within the rear triangle and enable the use of a larger 160mm rotor on the rear, as well as eliminate the need for a brace to be added.

The welds are perfect, and the cost was less than half of what Enigma quoted. Highly recommended titanium craftsman.

Tis been a long time since I was on this forum but this post summed exactly what I was looking for! Thank you.
I usually use Ted James but I cannot get hold of him atm...
Do you know of any other Ti welders?

•

ectoplasmosis in reply to @Multi_Grooves

You're welcome!

I came up with a few whilst working out what to do with this frame. Enigma quoted sky-high like they clearly didn't really want to do the job, a few small independents ummed and aahed and didn't inspire confidence, and I went in person to see Vernon Barker's work only to swiftly nope outta there.

Can't praise Limit enough; perfect welds and took the time to fabricate the custom mounts for my frame instead of just slapping on a generic tab.

About

Avatar for ectoplasmosis @ectoplasmosis started