You are reading a single comment by @gbj_tester and its replies.
Click here to read the full conversation.
-
I have no idea what they're called
Dzus might be what you're thinking of, e.g. https://www.ebay.co.uk/i/302700696271
I have no idea what they're called
Dzus might be what you're thinking of, e.g. https://www.ebay.co.uk/i/302700696271
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
gbj_tester
ffm
Is there a fitting that effectively does the job of a nut and bolt but can be released by hand i.e., something that can hold 2 thin flat pieces tight together by passing through a hole in both of them. I've seen fixings that use a pivoting, sliding section that can be aligned lengthways to pass through a hole in 2 plates and then turned 90 degrees to hold them together, but I have no idea what they're called.
Incidentally I don't want to use a wingnut as I want it to be one piece.