You are reading a single comment by @gbj_tester and its replies. Click here to read the full conversation.
  • Did not seem to have an answer on another thread so trying my luck here:
    Does anyone have an idea of the recommended torque to install a crankset on a square taper BB?
    Install it by feel usually but seem to have overtorqued the last one as crank arm is more engaged on one side so after a reference value for next installation.

  • Did not seem to have an answer on another thread so trying my luck here

    You wouldn't have had to ask in either thread if you'd only looked at the Shimano document which Hjusth kindly supplied. I might have done the same, but I'd have been much more snarky 🙂

  • when I searched I did not come across the Shimano documentation, but I wasn't looking for it either as the manufacturer of my crankset isn't Shimano. But as I've seen you mention quite a lot there is a ton of available doc by Shimano so should have thouht about it!

About

Avatar for gbj_tester @gbj_tester started