You are reading a single comment by @gbj_tester and its replies. Click here to read the full conversation.
  • This doesn’t look right, does it?

    I’ve switched a Cannondale SI forged crank arm for an SI Hollowgram arm. I assumed it’d be a straight swap. Do I need an additional spacer on the non drive side spindle/spline?

  • This doesn’t look right, does it?

    Doesn't look terrible in terms of overall length, the wave washer is touching both sides. If there's too much end float, it wouldn't hurt to put an extra shim in there.

  • Thanks for your reply. Makes me feel more confident trying it.

    I can’t create any wobble but seems odd to be able to see the spindle. If the wave washer compresses, won’t the spindle start fretting?

About

Avatar for gbj_tester @gbj_tester started