You are reading a single comment by @snoops and its replies. Click here to read the full conversation.
  • This doesn’t look right, does it?

    I’ve switched a Cannondale SI forged crank arm for an SI Hollowgram arm. I assumed it’d be a straight swap. Do I need an additional spacer on the non drive side spindle/spline?


    1 Attachment

    • 12E13151-22C4-4F15-BD40-46EB419A6C99.jpeg
  • This doesn’t look right, does it?

    Doesn't look terrible in terms of overall length, the wave washer is touching both sides. If there's too much end float, it wouldn't hurt to put an extra shim in there.

  • This doesn’t look right, does it?

    Looks OK. From the manual:

    check to see if wave washer is properly preloaded (still has slight wave and not loose). If it is loose, remove the crankarm and add another shim. Up to 3 shims can be used. Add shims as needed.

About

Avatar for snoops @snoops started