You are reading a single comment by @Brommers and its replies.
Click here to read the full conversation.
Brommers-
A 3/32" tensioner should work fine with a 1/8" chain
Not if the groove the chain runs in is narrower than the pin length of the chain. There are some ⅛" chains which are only 8mm across (e.g. KMC e101/X101) which are likely to fit, but most of them are over 9mm
-
As tester pointed out, the chain rubs on it quite a bit as it's too wide (the chain that is).
gbj_tester
Nef
Can you get an 1/8 inch chain compatible wheel for the DMR STS? Or does anyone have a suggestion to make it wider without making a mess off it. I don't have a lathe, lol.
