Any question answered...

You are reading a single comment by @Nef and its replies. Click here to read the full conversation.

•

Nef

Can you get an 1/8 inch chain compatible wheel for the DMR STS? Or does anyone have a suggestion to make it wider without making a mess off it. I don't have a lathe, lol.

•

Brommers in reply to @Nef

Why does it need to be wider? A 3/32" tensioner should work fine with a 1/8" chain.
•

|³|MA3K in reply to @Nef

A coarse file and a few minutes?

The material is soft and not much needs removing. If you do 'make a mess', no-one will notice.
•

Trunkie in reply to @Nef

Suitably sized bolt through the guide wheel clamped in drill chuck = ghetto lathe.

About

Avatar for Nef @Nef started