You are reading a single comment by @.gaz. and its replies.
Click here to read the full conversation.
-
Yes that's a good idea... I think I'm gonna try these Di2 grommets and run the wire along the inside of the ridge in the mudguard where there might be a tad more space.
I'll try and place the exit point just behind the caliper, so it's kind of hidden but the wire has enough space to turn the corner to the fork without adding too much stress on the tape.
If all else fails I'll just keep it on show and run it over the top of the brake.
Kind of handy for dynamo light fans that Di2 got invented.
.gaz.
Can you put another grommet on the side of the mudguard, and an adjacent eyelet as high up the fork leg as possible? The hard part is going to be keeping it off the tyre.
Duct tape should protect the cable a little bit from tyre rub. Not likely to be a problem on your front mudguards but can be on rears.