You are reading a single comment by @Polygon and its replies. Click here to read the full conversation.
  • I need to do this too - you can get glass measuring callipers for thickness if that’s what you mean. Overall glass size - not sure - I guess you can remove one trim - Measure the differential and then calculate overall size ?

  • I hadn't considered the thickness actually, good point. I'm hoping I might be able to measure with a regular caliper once I have one trim off. Think I'm gonna order those tools and give it a crack (bad choice of words).

  • I hadn't considered the thickness actually, good point. I'm hoping I might be able to measure with a regular caliper once I have one trim off. Think I'm gonna order those tools and give it a crack (bad choice of words).

    I find two flat knives are more use than the 7 function one.

    Can you collect the unit safely and without damaging it?
    They come without any packaging.

    https://www.screwfix.com/c/safety-workwear/work-gloves/cat850338
    The KS520 are probably a good idea.

    DGU overall thickness has mainly been 16, 20, 24 and 28mm. However I did a unit yesterday that was 22 (I actually deglazed it to try 24mm as the bottom half of the door has a 24mm panel!)
    Historically the spacer bars were silver or gold aluminium.
    Plastic warm edge spacers are available in silver, gold and black, and I tend to fit black unless it's beside other units that aren't being replaced.

    Deglazing it and measuring the thickness and width/height is a good idea if you don't have glass calipers to measure around a frame... Saves having to work out the bead clearance size too.

    Measure the overall thickness and edge to edge size and temporarily refit the two longest beads

    If it's 800mm or less from floor height to the glass, or in/joined onto a door then you'll need toughened glass.

    Do you want Low-U energy efficient glass?
    If it's newer than 2003 then it is more than likely Low-U that's fitted.

    Theres nothing stopping you from upgrading older units to Low-U, except the coating gives a very slight tint which may be noticeable if this is part of a multi paned window and you not replacing them all.

    It's not always reliable, as some coatings don't really show up well, but you can use a torch and look for a slight change of tint between the first and second reflections.

    650mm wide x 700mm high
    4mm clear float
    12mm silver spacer
    4mm clear float

    650mm wide x 700mm high
    4mm clear float
    20mm black warm edge
    4mm clear Low-U

    650mm wide x 700mm high
    4mm toughened clear
    20mm gold warm edge
    4mm toughened Low-U

About

Avatar for Polygon @Polygon started