hmmm ok if I screw plasterboard into the place where a light switch or light fitting has been what would I fix it to to get it close to flush?
Fix batten behind the wall, fix plasterboard to the batten, tape and then fill?
Crude drawing here. You could use 2 battens - one on either side if you prefer.
The unplastered board should sit below the finished plaster surface provided it's the same thickness board.
1 Attachment
Yeah that’s what I was thinking. Would mean needing to buy some plasterboard - unless anyone near E17 has some spare
@Nef started
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
hmmm ok if I screw plasterboard into the place where a light switch or light fitting has been what would I fix it to to get it close to flush?
Fix batten behind the wall, fix plasterboard to the batten, tape and then fill?