You are reading a single comment by @duncs and its replies.
Click here to read the full conversation.
-
Can't see any details of what WAN address the Unifi router is getting... presumably it's getting an external one and is able to see the modem (i.e. its gateway)
I have a Virgin hub as a router, and a Netgear R7000 hanging off it doing the rest. I don't have a switch connected currently (moved house, cables need to be run) but did previously and it worked fine.
Virgin Router 86.x.x.1 <-> Netgear WAN 86.x.x.29
Netgear LAN 192.168.0.1 <-> Switch/Wireless <-> Clients 192.168.0.10-99
no crossover cables, all just the nearest available length of Cat5/Cat6
1 Attachment
-
duncs
rj
I am trying this
Virgin superhub 3 (in modem mode) bottom ethernet port > USG WAN1
USG LAN1 > Unifi switch 8 port 1
Pi running Unifi controller > Unifi switch 8 port 1
AP PoE > Unifi switch 8 port 5
I can see everything on the controller, but get no internet connection from the hub to the USG
I get internet by connecting RPi to hub directly and disconnecting the USG
I've moved the LAN Gateway IP/Subnet from 192.168.1.1 to 192.168.99.1 and I've attached some screenshots of my settings in the likely case I am doing something stupid