You are reading a single comment by @MCamb and its replies. Click here to read the full conversation.
  • Finally wired up my rear light mounted to the pannier rack. Maybe a lack of imagination but I couldn’t really think of a satisfactory method to route the wire from frame along rack to light.

    Did consider drilling a hole or two in the rack.. which I guess is reasonable? Not like I’m carrying super heavy stuff on it.


    1 Attachment

    • F04D64D4-B597-4EB8-A33C-5A5610155070.jpeg
  • I’ve worked rear cables through rack tubes on a couple of bikes, it’s fine so far. Faff getting it through obvs.

    One of them (a tubus) had an open end of the tube, so it was pretty easy to drill, and feed the wire through from that end down to the open end. Watch out you remove burrs around your drillings so you don’t split your cable housing.

About

Avatar for MCamb @MCamb started