Dynamo Lights

You are reading a single comment by @le_james and its replies. Click here to read the full conversation.

•

grams in reply to @le_james

It’s an ideal way to route it in my book.

You might consider tying it to the mounts rather than to the hose so maintenance can be done independently, but replacing the hose is a rare enough event it’s probably not worth it.

•

le_james in reply to @grams

I appreciate the sanity check :)

I've actually spiralled it around the hose now, and have cable tied it to the hose at the mount points and to the frame in a few places, mainly thinking of keeping any stresses off the cable. Fingers crossed hose maintenance doesn't come up too often, it was a faff getting the discs set up!

•

krad in reply to @le_james

You can shrink wrap tube, it to the cable. I run mine along side the front gear cable and under the frame. If you also use black gear cable it not noticeable. Just use clear tape to hide the cable. You then just replace this every so often along with annual service.

About

Avatar for le_james @le_james started