You are reading a single comment by @kboy and its replies.
Click here to read the full conversation.
-
Thanks! had a look through and the levers aren't Rival, but looks very similar? Looking through the manual my understanding is that I can just swap them over but should prob replace o-rings?
kboy-
Thanks! had a look through and the levers aren't Rival, but looks very similar? Looking through the manual my understanding is that I can just swap them over but should prob replace o-rings?
Apex? Pull back the hood cover, if there is a 4 bolt resovoir cover.. good chance it's all the same inners. I didn't replace the o-rings, on both occasions I've done this, they were new levers.
spinnnout
Not watched the video but SRAMs own service manuals are pretty decent.
https://www.servicearchive.sram.com/sites/default/files/techdocs/gen0000000005217_hydror_rev_d_english.pdf
A few tips..
Do use a torque wrench, especially on the banjo bolt. Do follow the sequence when refitting the resovoir cover - I didn't and it slowly leaked until redone.