You are reading a single comment by @fizzy.bleach and its replies.
Click here to read the full conversation.
-
yeah i have a y splitter thing from the bottle, which works fine.
Tigging the stop on should be ok i think. just move quick, try not to sink loads of heat into it. Might be wise to try and avoid placing it over the butt transition. Easier said than done as its hard to find the butt on a frame thats already together, but afaik its a good bet to avoid placing things over the transition zone. When i put braze ons on i always avoid it.
Biggles567
@fizzy.bleach
and while i'm here, i'd like to pop a couple of triple cable stops along the top tube. this sort of thing.
i have no brazing torch, so was thinking of tig pulsing around the plate with no filler. i can't imagine the forces are insane enough to snap that off...
1 Attachment