You are reading a single comment by @stevo_com and its replies.
Click here to read the full conversation.
-
Otherwise, how would they have been connected in the first place?
This is what I initially thought, but then couldn't work out if they used some sort of pull string.
Not sure if it's clear from the photo, but there aren't any under the units / washers. Would a good solution to stop things getting stuck again be to put a square of ply the same thickness as the height difference?
Marine ply should be fine right?
hugo7
@stevo_com
For future. The hoses should be long enough for you to pull the machine out fully. Or at the very least, long enough for you to pull the machine out far enough for you to turn off the water and disconnect them. Otherwise, how would they have been connected in the first place? Unless the installer was a contortionist/sadist and connected everything up in situ.