Home DIY

You are reading a single comment by @Airhead and its replies. Click here to read the full conversation.

•

Hovis in reply to @Airhead

Can you not take 3mm off the end of a board. That would be amazing if you had just the right amount of material to within 3mm :)

Well you say that... 4m long boards, variance of 2mm between them, I'll be trimming a maximum of 2mm...

I paid a fortune for them, I'm using them all! Just also a little paranoid.

The rip is 3m long so not insignificant. But you're right it's more than 3mm so I'll do a test or two.

•

Airhead in reply to @Hovis

I had discounted you doing that rip, when you said threshold I was visualising something smaller. The popular size of track saw usually needs a blade with fewer teeth for a rip that long otherwise it will likely get bogged down at any speed.

No pressure then :)

About

Avatar for Airhead @Airhead started