-
I've not done the job but it doesn't sound as if you are going to be ripping huge lengths so a fine blade would be the first part. I don't often slow my saw down. I suppose I listen to it and adjust a bit if it's sounds odd.
Can you not take 3mm off the end of a board. That would be amazing if you had just the right amount of material to within 3mm :)
Airhead-
Can you not take 3mm off the end of a board. That would be amazing if you had just the right amount of material to within 3mm :)
Well you say that... 4m long boards, variance of 2mm between them, I'll be trimming a maximum of 2mm...
I paid a fortune for them, I'm using them all! Just also a little paranoid.
The rip is 3m long so not insignificant. But you're right it's more than 3mm so I'll do a test or two.
Hovis
Both actually, cross cut of them all to length, and one scribing to a door threshold.
@TW thanks, I have a few too actually, bit small though so not sure how I'll be able to test on them.