You are reading a single comment by @Hovis and its replies.
Click here to read the full conversation.
-
Both actually, cross cut of them all to length, and one scribing to a door threshold.
@TW thanks, I have a few too actually, bit small though so not sure how I'll be able to test on them.
Hovis-
I've not done the job but it doesn't sound as if you are going to be ripping huge lengths so a fine blade would be the first part. I don't often slow my saw down. I suppose I listen to it and adjust a bit if it's sounds odd.
Can you not take 3mm off the end of a board. That would be amazing if you had just the right amount of material to within 3mm :)
Airhead
Ripping or crosscutting?