You are reading a single comment by @mcJ78 and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
mcJ78
I've inserted a straight pull spoke, used digital calipers to measure from the inside of the flange to the outer edge of the spoke, and then done a bit of maffs to work out where the centreline of the spoke hole is compared to the centre of the axle. It matched up exactly with what the manufacturer said it was, but I don't like relying on manufacturer's dimensions if I can measure them myself.